NuTone warranty Typical Installations, Model 758NT, Discharge 90 0 to joists

MODEL 758NT

Page 1

DECORATIVE SERIES

CEILING VENTILATOR

READ AND SAVE THESE INSTRUCTIONS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OB- SERVE THE FOLLOWING:

1. Use this unit only in the manner intended by

the manufacturer. If you have questions, con-

tact the manufacturer at the address or tele-

phone number listed in the warranty.

2. Before servicing or cleaning unit, switch power

off at service panel and lock the service dis-

connecting means to prevent power from be-

ing switched on accidentally. When the ser-

vice disconnecting means cannot be locked,

securely fasten a prominent warning device,

such as a tag, to the service panel.

3. Installation work and electrical wiring must be

done by a qualified person(s) in accordance

with all applicable codes and standards, in-

cluding fire-rated construction codes and stan-

dards.

4. Sufficient air is needed for proper combus-

tion and exhausting of gases through the flue

(chimney) of fuel burning equipment to pre-

vent backdrafting. Follow the heating equip-

TYPICAL INSTALLATIONS

*

HOUSING MOUNTED	HOUSING MOUNTED
DIRECTLY TO JOIST	ADDITIONAL FRAMING
2x6 (or larger)	Discharge 900 to joists.
Discharge parallel to joists.

*

	ment manufacturer’s guideline and safety
	standards such as those published by the
	National Fire Protection Association (NFPA),
	and the American Society for Heating, Refrig-
	eration and Air Conditioning Engineers
	(ASHRAE), and the local code authorities.
5.	When cutting or drilling into wall or ceiling, do
	not damage electrical wiring and other hid-
	den utilities.
6.	Ducted fans must always be vented to the out-
	doors.
7.	NEVER place a switch where it can be
	reached from a tub or shower.
8.	This unit must be grounded.
9.	This unit is U.L. listed. Type I.C. inherently

HOUSING MOUNTED

TO 2x4 TRUSS

Requires additional framing

for mounting tabs.

Discharge parallel to joists.

*

HOUSING MOUNTED TO 2x4

TRUSS

Requires additional framing

for mounting tabs.

Discharge 900 to joists.

protected.

CAUTION !

1.	For general ventilating use only. Do not use
	to exhaust hazardous or explosive materials
	and vapors.
2.	This product is designed for installation in
	FLAT CEILINGS ONLY. Do not mount this
	product in a wall.
3.	The light fixture assembly must be mounted
	to the fan housing assembly included with this
	product. Do not mount the light fixture as-
	sembly to a wiring outlet box.
4.	To avoid motor bearing damage and noisy
	and/or unbalanced impellers, keep drywall
	spray, construction dust, etc. off power unit.

*

HOUSING MOUNTED TO “I” JOIST

Requires additional framing

for mounting tabs.

Discharge parallel to joists.

*

HOUSING MOUNTED TO “I” JOIST

Requires additional framing

for mounting tabs.

Discharge 900 to joists.

5. Please read specification label on product for

further information and requirements.

*Additional framing must be a 2x6 (minimum height), at least 9-inches long.

Installer: Leave this manual with the homeowner.

Homeowner: Use and Care information on page 4.