Zanussi Comprehensive Cooker Hood Fitting Instructions for Safe Installation

Instructions for the Installer

Engineers technical data

Heating elements Ratings			Overall dimensions
			Width:	580 mm.
Normal front left Hotplate	Ø 180 mm	1570 W
			Depth:	500 mm.
Normal back left Hotplate	Ø 145 mm	1040 W
Rapid front right Hotplate	Ø 145 mm	1570 W
Rapid back right Hotplate	Ø 180 mm	2090 W
Total rating		6270 W

Cut out dimensions

Width:	550 mm.
Depth:	470 mm.

Important safety requirements

This hob must be installed in accordance with the IEE Wiring Regulations (Current Edition).

Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891 Current Editions.

Location

This hob has been registered as a "Class X" appliance according to Fire Risk Regulations. Minimum distances detailed below must be observed. The hob may be located in a kitchen, a kitchen/diner or bed sitting room, but not in a bathroom or shower room.

Before making the cut out in the worktop ensure that there is a minimum distance of 55 mm. between the rear edge of the hob and the wall. A minimum distance of 100

mm.must be left between the side edges of the hob and any adjacent cabinets or walls.

The minimum distance combustible material can be fitted above the hob in line with the edges of the hob is 400 mm. If it is fitted below 400 mm. a space of 50 mm. must be allowed from the edges of the hob.

The minimum distance combustible material can be fitted directly above the hob is 700 mm.

INSTALLATIONGUIDANCEINSTRUCTIONS
		CLEARANCES REQUIRED
		WHEN FITTING THE HOB
	WITHOUT A COOKER HOOD ABOVE
700 mm
	400 mm
		mm
	50	55
		mm		400 mm
100	mm
		50	mm
FO 0812

INSTALLATIONGUIDANCEINSTRUCTIONS
		CLEARANCES REQUIRED
		WHEN FITTING THE HOB
	WITH A COOKER HOOD ABOVE
		600 mm
650 mm
	400 mm
		mm
	50	55
		mm		400 mm
100	mm
		50	mm
FO 0813

10