Cleaning and
Maintenance
Continued
2.Locate flame generation cylindrical drum (see Figure 7). It is constructed of two removable halves; either of which can be removed from the unit.
3.Squeeze half of drum cylinder until it's top edge clears the top drum track (see Figure 8). Remove bottom edge of cylinder drum from bottom drum track. This will give you access to the light bulbs. Note: Do not exert exces- sive pressure on drum cylinder as this may cause damage.
4.Remove spring clip. Hold socket and pull out old bulb.
5.Hold socket and push in new bulb (DO NOT exceed wattage). Replace spring clip.
6.Repeat steps 3 and 4 for second bulb.
Flame Cylinder
Drum
7.Insert bottom edge of removed cylinder half into bottom drum track. Gently squeeze drum cylin- der until it's top edge fits into top drum rack.
8.Replace louvered back panel.
Replacing Glass
1. Remove top of stove by sliding top toward the back (see Figure 9). Top fits into slots and should slide off easily.
2. Remove four screws securing back control panel (see Figure 10). DO NOT STRESS WIRES.
3. Remove four screws securing heater/blower assembly to stove assembly (see Figure 10). Assembly must be held securely while remov- ing screws.
Top of Stove
Figure 9 - Removing Top of Stove
Glass
PanelHeater/Blower
Assembly
Figure 7 - Flame Cylinder Drum Location
Flame
Cylinder Drum
Back Control
Panel
Figure 8 - Flame Generation Cylinder
Drum
Figure 10 - Removing Glass Panel
www.desatech.com |