Zanussi BMF 849, BMS 841 When the oven is first installed, Using the Oven, Condensation and steam

When the oven is first installed

Before cooking for the first time, carefully wash the oven accessories.

The oven will work only if the time of day has been set with the electronic programmer.

ΦOnce the oven has been installed:

a)set the thermostat knob to MAX (250);

b)switch the oven function control knob to conventional

cooking ( );

c)allow the oven to run empty for approximately 45 minutes;

d)open a window for ventilation.

During this time, an unpleasant odour may be emitted. This is absolutely normal, and is caused by residues of manufacturing.

Repeat this operation for the grill and fan cooking function. Once this operation is carried out, let the oven cool down, then clean the oven cavity with a soft cloth soaked in warm

Fig. 4

FO 2161

soapy water.

To open the oven door, always catch the handle in its central part (Fig. 4).

Using the Oven
	Always cook with the oven door closed.
•	Stand clear when opening the drop down oven door. Do not			4
	allow it to fall open - support the door using the door handle,			3
	until it is fully open.
				2
•	Theovenhasfourshelflevels.Theshelfpositionsarecounted
	from the bottom of the oven as shown in the diagram.			1
•	Do not place cookware directly on the oven base.
Condensation and steam		Fig. 5	FO 0019
When food is heated it produces steam in the same way
as a boiling kettle. The oven vents allow some of this
steam to escape. However, always stand back from
the oven when opening the oven door to allow any		Model BMF 849		Model BMS 841
build up of steam or heat to release.
If the steam comes into contact with a cool surface on the
outside of the oven, e.g. a trim, it will condense and
produce water droplets. This is quite normal and is not a
fault with the oven. To prevent discoloration, regularly
wipe away condensation and also soilage from surfaces.
Telescopic shelf supports (fig. 6)
-	Mod. BMF 849: Shelf level 2 is fitted with telescopic
	shelf supports.
-	Mod. BMS 841: Shelf levels 2 and 4 are fitted with
	telescopic shelf supports.
1.	Pull the right and left hand telescopic shelf supports
	completely out, as shown in the diagram.
2.	Place the shelf or the grill pan on the telescopic shelf
	supports, as shown in the diagram, then gently push
	them all inside the oven.
	Do not attempt to close the oven door if the
	telescopic shelf supports are not completely
	inside the oven. This could damage the door			Fig. 6
	enamel and glass.

5