Zanussi Oven manual Electrical connection, Securing the oven to the cabinet, Terminal block

Securing the oven to the cabinet

-Fit the appliance into the cabinet recess.

-Open the oven door and secure the oven to the kitchen cabinet with four wood screws, which fit the holes provided in the oven frame (Fig.16).

When installing an electric plate hob over the oven, the hob's electrical connection and the oven's one have to be carried out separately, for security reasons and to let the oven be taken off the unit easier, if necessary.

Fig. 16

FO 0039

Electrical connection

Before the appliance is connected:

1)check that the main fuse and the domestic installation can support the load;

2)check that the power supply is properly earthed in compliance with the current rules;

3)check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the forniture unit.

If connecting the appliance directly to the electric system, a double pole switch must be installed between the appliance and the electricity supply, with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current rules. The earth wire must not be interrupted by the double switch pole.

The connection cable has to be placed in order that, in each part, it cannot reach a temperature 50 °C higher than the room temperature.

After the connection is carried out, test the heating elements for about 3 minutes.

Terminal block

The oven has an easily accessible terminal block, which is meant to work with an electric single-phase rate of 230 V (Fig. 17).

The manufacturer disclaims	any
responsability should all the safety
measures not be carried out.	Fig. 17 FO 2159

14