Zanussi ZPB 1260 manual How to use the pyrolytic cleaning function

How to use the pyrolytic cleaning function

Before activating the pyrolytic cleaning function, remove any excessive spillage and make sure that the oven is empty. Do not leave anything inside it (e.g. pans, grids, baking tray, dripping pan, etc.) as this could heavily damage them.

Ensure that the oven door is closed before activating the pyrolytic cleaning function.

When the pyrolytic cleaning function is on, it is advisable not to use the hob as this could cause overheating and damage the appliance.

During the pyrolytic cleaning cycle the oven door becomes hot. Children should be kept away until it has cooled.

Choose this function to clean the oven by pyrolysis. The following pyro levels are available:

Pyrolytic 1 (P I) time : 2 h = 30 min heat-up +1 h at 480°C + 30 min cooling down.

Pyrolytic 2 (P 2) time : 2 h 30 min. = 30 min heat-up +1 h 30 min at 480°C + 30 min cooling down.

The pyro duration time cannot be changed.

To activate the pyrolytic cleaning function proceed as follows:

1.Press button to switch on the oven. Press the

button as often as necessary, until the “Pyro“

function symbol (level 1 - P I) will appear on the display (Fig. 18).

2.The Cooking Duration symbol will flash for 5

seconds; during this time push ' ' or ' ' buttons to select the pyrolytic 1 (P I) or pyrolytic 2 (P 2) function (Fig. 19).

3.Once you have chosen the desired pyrolytic function, the “Pyro” writing will flash on the display waiting for confirmation to start the pyro cleaning function . If ' ' or ' ' buttons are pushed, the Cooking Duration

symbol will flash again to allow you to change the pyro selection (P I or P 2) (Fig. 19).

4.To confirm which pyrolytic function you desire, press

button , the “Pyro” text will stop flashing and the pyrolytic cleaning cycle starts (Fig. 20).

5.After some time, the door lock will be activated and

the related symbol will be displayed (Fig. 21). At this time the button is no more active.

At the end of the pyrolitic cleaning process, the display shows the time of day. The oven door is locked.

Once the oven has cooled down, an acoustic signal will be emitted and the door will unlock.

To stop the pyrolytic cleaning cycle at any time, press button .

NOTE: The time indication is comprehensive of the cooling down time.

If you select a cooking function while the pyrolytic

function is active, the cleaning cycle will be inter- rupted.

If the oven door lock is activated, it is impossible to select any cooking function until the door lock

16is off.

Fig. 18

Fig. 19

Fig. 20

Fig. 21