The Singing Machine SMVG-600 owner manual Antenna

Page 4

IMPORTANT SAFETY INSTRUCTIONS

12.Grounding or Polarization - This product may be equipped with a polarized alternating current line plug (a plug having one blade wider than the other). This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

Alternate Warnings - This product may be equipped with a three-wire grounding-type plug, a plug having a third (grounding) pin. This plug will only fit into a grounding-type power outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the grounding-type plug.

13.Power-Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the product.

14.Protective Attachment Plug - The product is equipped with an attachment plug having overload protection. This is a safety feature. See Instruction Manual for replacement or resetting of protective device. If replacement of the plug is required, be sure the service technician has used a replacement plug specified by the manufacturer that has the same overload protection as the original plug.

15.Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See figure:

 

ANTENNA

 

LEAD IN

 

WIRE

GROUND

 

CLAMP

 

 

ANTENNA

ELECTRIC

DISCHARGE UNIT

(NEC SECTION 810-20)

SERVICE

 

EQUIPMENT

GROUNDING CONDUCTORS

 

 

(NEC SECTION 810-21)

 

GROUND CLAMPS

NEC-NATIONAL ELECTRICAL CODE

POWER SERVICE GROUNDING

S2898A

ELECTRODE SYSTEM

 

(NEC ART 250. PART H)

3

Image 4
Contents SMVG-600 Dripping Warning Ventilation WarningImportant Safety Instructions Antenna Important Safety Instructions Singing Machine Karaoke Glossary of Terms CDGIntroduction Control Locations Front ViewSide View Rear ViewConnecting Power Connecting to Your TVMaking the Connections For UK onlyVideo Connection for TV Rear View Singing MachineRear View of TV Video Connection for VCR recordingCommon Ways to Configure Your TV or VCR Connecting a Video Component for Input Audio ConnectionConnecting AN Audio Component for Input Monitor SelectorVideo OUT Selector Audio SelectorCD or CD+G Operation PLAY/PAUSE Mode Stop ModeRepeat Play Program PlayCare and Maintenance Trouble Shooting Guide Problem Possible Cause SolutionVCR Specifications Page Page Page Singing Machine Company, Inc