A
C
P R 3 3 / 2
6.Fix cover (C) on guide (A) until it clips into place.
8mm |
A |
B |
PR167 |
7.Open the appliance door and the furniture door at 90°. Insert the small square (B) into guide (A). Put together the appliance door and the furniture door and mark the holes as indicated in the figure.
Remove the squares and drill holes with Ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied.
PR168 |
8.Should the lining up of the furniture door be neces- sary, use the clearance of slots.
At the end of operations, it is necessary to check if the door of the furniture closes properly.
B
D
PR167/1
9.Fix cover (D) on guide (B) until it clips into place.
Fitting the plinth
Important
For the efficient operation of the appliance, it is important that the original ventilation grid is used.
S.I.007
■For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm.
A = 820 | B = 870 | 100 150 |
|
| a = b = |
|
| 580 |
| 25 | - |
| 25 | 80 |
|
| |
S.I.008 |
|
|
■For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 mm wide, in the centre of the appliance position, leav- ing a remaining height of a=100 mm, b=150 mm.
■Attach plinth to the kitchen units.
Important
The plinth must be positioned at a minimun distance of 25 mm from the door.
15