Zanussi ZCR135R manual Something Not Working, Symptom Solution

Something Not Working

Before contacting your local Service Force Centre check the following points:

Symptom	Solution
The temperature is too high inside the	Set a lower temperature.
refrigerator.	Put food products in the right place inside the refrigerator. See
	the chapter "Temperature inside the refrigerator".
	Distribute the food products to allow cold air to circulate
	around them.
	Make sure that the door is completely closed and that the
	insulating strip is complete and clean.
It is too cold inside the refrigerator.	Set a higher temperature.
	Vegetables and other products that are easily frozen have been
	placed on a "too cold" shelf. See the chapter "To start the fridge
	and thermostat control".
There is water on the cooling plate inside	This is normal. During automatic defrosting, frost thaws on the
the refrigerator.	cooling plate.
Water is running inside the refrigerator.	Clean the water drain and drain hole inside the refrigerator
	using e.g. cotton swabs or a bottle cleaner brush.
	Food products could have been placed stopping the water from
	running into the drain.
Water comes out on the floor.	Place the drain hose at the back of the cabinet above the drain
	bowl. See the chapter "Before use"
The compressor operates continuously.	Set a higher temperature.
	Make sure that the door is completely closed and that the
	insulating strip is complete and clean.
The cabinet does not operate at all.	The power plug is not properly connected.
Cooling or interior light does not	The fuse has blown.
operate. No indicator lamps light.	The cabinet is not switched on.
	Power does not reach the cabinet. (Try connecting another
	electrical device to the power outlet.)
Noise	See "Normal operating Sounds" in chapter
	Hints and Tips.
	If the cushion spacers (between the cabinet wall and pipes)
	come loose, put them back in place again.
	Carefully follow the instructions in the chapter "Installing the
	cabinet".

If after above checks there is still a fault call your local Service Force Centre.

In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for in-guarantee service calls.

Zanussi 818 14 54-03/7

9