Zanussi ZEBF 250 W manual Installation, Positioning, Rear spacers

Page 14

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal directions” paragraph.

Important

Positioning

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each climate classification:

SN +10°C to + 32°C

N+16°C to + 32°C

ST +18°C to + 38°C

T+18°C to + 43°C

It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.

mm100

A mm10 NP00

B

10 mm

You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4”) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath.

Rear spacers

The plastic bag containing all relevant documentation also contains two spacers to be fitted into special holes in the back of the appliance.

Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in the diagram. Then turn them through 45° (arrow (A) vertical) until they lock into place.

DO NOT install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers or a tool (see figure).

A

45°

PR60

D200

14

Image 14
Contents Refrigerator Freezer Important Safety Information InstallationContents Operation Before usingSetting the temperature Control panelPositioning the inner shelves Fresh food refrigerationPositioning the door shelves Frozen food storage Freezer compartmentFreezing fresh food Ice cube tray holderNormal Operating Sounds Health and Safety Guidelines Maintenance and Cleaning Symptom Solution Something not Working9 9 2 Service and Spare PartsCustomer Care Department European Guarantee Guarantee ConditionsStandard guarantee conditions ExclusionsTechnical Specifications NET CapacityRear spacers InstallationPositioning Electrical connections Green and Yellow Earth Blue- Neutral Brown- LiveDoor reversal directions Page Page Page Electrolux plc