What to do if…

•defrost 3)and clean the appliance and all accessories

•leave the door/doors ajar to prevent unpleasant smells.

If the cabinet will be kept on, ask somebody to check it once in a while to prevent the food inside from spoiling in case of a power failure.

Warning! Before troubleshooting, disconnect the mains plug from the mains socket.

Only a qualified electrician or competent person must do the troubleshooting that is not in this manual.

Important! There are some sounds during normal use (compressor, refrigerant circulation).

Problem		Possible cause
The appliance does not operate.		The appliance is switched off.
The lamp does not operate.
		The mains plug is not connected to the
		mains socket correctly.
		The appliance has no power. There is
		no voltage in the mains socket.

The lamp does not work.		The lamp is in stand-by.
		The lamp is defective.
The compressor operates con-		The temperature is not set correctly.
tinually.
		The door is not closed correctly.
		The door has been opened too fre-
		quently.
		The product temperature is too high.

		The room temperature is too high.
Water flows on the rear plate of		During the automatic defrosting proc-
the refrigerator.		ess, frost defrosts on the rear plate.
Water flows into the refrigerator.		The water outlet is clogged.
		Products prevent that water flows into
		the water collector.
Water flows on the ground.		The melting water outlet does not flow
		in the evaporative tray above the com-
		pressor.
The temperature in the appliance		The temperature regulator is not set
is too low.		correctly.
The temperature in the appliance		The temperature regulator is not set
is too high.		correctly.

Switch on the appliance.

Connect the mains plug to the mains socket correctly.

Connect a different electrical appliance to the mains socket.

Contact a qualified electrician.

Close and open the door.

Refer to "Replacing the lamp".

Set a higher temperature.

Refer to "Closing the door".

Do not keep the door open longer than necessary.

Let the product temperature decrease to room temperature before storage.

Decrease the room temperature.

This is correct.

Clean the water outlet.

Make sure that products do not touch the rear plate.

Attach the melting water outlet to the evaporative tray.

Set a higher temperature.

Set a lower temperature.

3)If foreseen.