Installation, Positioning, Shelf holders

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Positioning

This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each climate classification:

SN +10°C to + 32°C

N +16°C to + 32°C

ST +18°C to + 38°C

T +18°C to + 43°C

It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.

You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4”) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers (see figure).

Shelf holders

Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation.

To remove them proceed as follows:

Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal directions” paragraph.

Important

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

100 mm
A	B
10 mm	10 mm
NP005
D200
	A
	B

ZETF 235 specifications

The Zanussi ZETF 235 is a remarkable refrigerator that embodies efficiency and innovation. Designed for optimal food preservation, it features an array of advanced technologies and practical characteristics that cater to modern household needs.

One of the standout features of the ZETF 235 is its spacious interior, providing ample storage for groceries and perishables. With adjustable shelving, users can customize the layout to accommodate larger items, ensuring that nothing goes to waste. The refrigerator's total capacity is generous, allowing families to store food efficiently without the need for frequent grocery trips.

Energy efficiency is a key characteristic of the Zanussi ZETF 235. It is equipped with an A+ rating, meaning it consumes significantly less energy compared to lower-rated models. This not only helps reduce electricity bills but also contributes to a more sustainable lifestyle. The design incorporates advanced insulation technologies, minimizing energy loss and maximizing cooling performance.

The ZETF 235 also boasts a No Frost system, which prevents ice build-up in both the refrigerator and freezer compartments. This feature eliminates the need for manual defrosting, saving users time and effort. The consistent temperature control ensures that food stays fresh for longer, reducing spoilage and waste.

In terms of user convenience, the Zanussi ZETF 235 includes a variety of compartments designed for different types of food. The crisper drawers maintain optimal humidity levels for fruits and vegetables, keeping them fresh and crunchy. Additionally, the adjustable door shelves can accommodate bottles and jars of various sizes, enhancing storage versatility.

Another notable feature is the fast freeze function. This technology ensures that newly added items are frozen quickly, preserving their quality and nutrients. It is particularly useful for batch cooking or freezing seasonal produce.

The design of the Zanussi ZETF 235 is both sleek and practical. Its modern aesthetic fits effortlessly into any kitchen decor, while the robust build ensures durability. The user-friendly controls make it easy to adjust settings and monitor temperatures at a glance.

Overall, the Zanussi ZETF 235 combines functionality with cutting-edge technology, making it an ideal choice for families and individuals alike who prioritize efficiency and convenience in their kitchen appliances.