Zanussi ZU 9124 manual Defrosting

DEFROSTING

The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located beneath the appliance adja- cent to the compressor, where it evaporates.

Important

To avoid defrost water overflowing and dripping onto the food in the fridge, periodically clean the water discharge hole (F) situated under the salad bins. Use the special cleaner provided

(P)which you will find already inserted into the discharge hole

The freezer compartment, however, will become pro- gressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs.

Never use sharp metal tools to scrape off frost from the evaporator as you could damage it.

Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer.

However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows:

1.pull out the plug from the wall socket or turn the thermostat knob to the «O» setting;

2.remove any stored food, wrap it in several layers of newspaper and put it in a cool place;

3.leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, remove the plug as shown in the figure;

4.when defrosting is completed, dry the interior thoroughly and refit the plug.

Keep the scraper for future use; turn the thermostat knob back to the required setting or replace the plug in the power socket. After two or three hours, reload the previously removed food into the compartment.

Important

A temperature rise of the frozen food packs, during defrosting, may shorten their safe stor- age life.

P F

S.I.011

PR151

8