Texas Instruments TAS5727 quick start DRC Options

Page 11

www.ti.com

Using the EVM Software

Figure 12. DRC Options

The crossover frequency for the 2-band DRC by default is 300Hz. This can be modified by entering a new value in the property window.

The DRC rates for the softening filter, attack, and release can also be adjusted. To set these rates, first click on the UPPERBAND or LOWERBAND block. Second, set the RateSliders property to On for that block. Third, double-click on the block to bring up an advanced DRC options window, as shown in Figure 13.

Figure 13. Advanced DRC Options

PBTL Mode: To run the device in PBTL Mode, the PBTL pin must be driven high. Then in the GUI, select woofer instead of stereo (stereo is the default value). The source for PBTL is selected as (L+R)/2, but that be changed by updating input mixer values.

SLOU299 –December 2010

TAS5727 25W Digital Input Amplifier—with EQ and 2-Band DRC

11

Submit Documentation Feedback

 

 

© 2010, Texas Instruments Incorporated

Image 11
Contents TAS5727 25W Digital Input Amplifier with EQ and 2-Band DRC Overview EVM Installation TAS5727EVM and MC57xxPSIA FeaturesLoudspeaker Connectors Connecting the TAS5727EVM to MC57xxPSIARecommended Power Supplies ADC Interface Software InstallationBoard Power-Up General Guidelines Digital Audio Interface SpdifInstallation Process Structure I2C Memory Tool Connect the GUI to the EVMBiquad GUI Volume FunctionDRC GUI DRC Options GDE Target Connect Using The Fault PIN As An Error IndicatorCommon Configurations RCA/OPTICAL Jumpers SwitchesLED Indicators TAS5727EVM and MC57xxPSIA Board Layouts TAS5727EVM Top Composite AssemblyBill of Materials for TAS5727EVM Bill of MaterialsOUT SchematicsUSB Interface Spdif Receiver ADC / Connector I/O FCC Warning Evaluation BOARD/KIT Important NoticeImportant Notice