Installation, Location, Power connection

INSTALLATION

If this refrigerator featuring magnetic door seals is to replace an older appliance having a spring lock on the door or lid, be sure to make that spring lock unusable before you discard the old appliance.

This will prevent it from becoming a death-trap for a child.

Location

Place the appliance as far away as possible from sources of heat, e.g. radiators, heaters, direct sunlight, etc. The best results are achieved with a room temperature ranging from +16°C to +32°C (class N) or from +18°C to +38°C (class ST). The class of your appliance is shown on its rating plate.

Power connection

Before plugging the appliance into the mains socket, check that the voltage and frequency indicated on the appliance’s rating plate are the same as those provided by your home power supply. A 6% ﬂuctuation above or below rated voltage is acceptable.

For operation using different voltages you should use an autotransformer of suitable capacity.

The appliance’s plug and the wall socket are fully compatible, without any need to use adaptors, multiple plugs, etc. If this is not the case, the wall socket should be replaced to make it compatible.

The appliance MUST be connected to an efficient earth or ground tap.

The supply lead plug in fact incorporates a special earth or ground contact for this purpose. If by any chance the sockets of your domestic wiring system are not earthed, the appliance must be connected to a separate earth or ground wire by a qualiﬁed electrician, in accordance with existing safety regulations.

The manufacturer declines to accept any liability if this accident-prevention procedure is not followed.

This appliance complies with E.E.C. directive no. 87/308 of 2.6.87 relative to radio interference suppression.

This appliance complies with the following E.E.C. Directives:

-73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modiﬁcations;

-89/336 EEC of 3.5.89 (Electromagnetic Compa- tibility Directive) and subsequent modiﬁcations.

Cleaning the appliance’s interior

Before using the appliance for the ﬁrst time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then drv thoroughly.

Do not use detergents or abrasive powders as these will damage the ﬁnish.

Instructions for total built-in

Door reversibility

Right-hand opening

Remove the pins (A) and (B).

Left-hand opening

Remove pins (A) and (C) from both sides and the door. Remove the middle hinge and reﬁt it on the opposite side. Reﬁt the door and pin (A) on the left side. Remove pin (D) from the right side.

Housing’s dimensions

Height	1580 mm
Depth	550 mm
Width	560 mm

Fig. 1

A	1	C
	1
	2
	3
B		D
D501
		13

ZI 428 D specifications

The Zanussi ZI 428 D is a sophisticated built-in refrigerator designed to cater to modern kitchen needs while offering efficient performance. It represents a blend of functionality, aesthetic appeal, and energy efficiency, making it an appealing choice for homeowners looking to optimize their kitchen space.

One of the standout features of the Zanussi ZI 428 D is its spacious interior. With a total capacity of around 275 liters, this refrigerator provides ample room for groceries, beverages, and perishables. The layout is intelligently designed, featuring adjustable shelves that allow users to customize the interior according to their storage needs. Additional door balconies provide extra space for bottles and jars, ensuring that everything remains organized and easily accessible.

In terms of temperature control, the Zanussi ZI 428 D incorporates advanced cooling technologies. The refrigerator utilizes a dynamic cooling system that maintains a consistent temperature throughout the unit, reducing temperature fluctuations that could compromise food preservation. This technology also helps in minimizing energy consumption, aligning with the unit's high energy efficiency rating. This is further enhanced by the use of LED lighting, which not only illuminates the interior beautifully but also consumes less energy than traditional bulb lighting.

Another appreciated feature of this model is its low-noise operation, which is crucial in maintaining a peaceful home environment. The Zanussi ZI 428 D operates quietly, making it suitable for open-plan living spaces where noise levels can be a concern.

Frost-free functionality is another key characteristic of the Zanussi ZI 428 D. This feature eliminates the need for manual defrosting by preventing ice buildup, ensuring that users enjoy a hassle-free maintenance experience. It also promotes better air circulation within the refrigerator, which is beneficial for preserving food freshness over time.

The design of the Zanussi ZI 428 D is sleek and modern, easily blending with various kitchen decors. Its integrated design ensures that it fits seamlessly with cabinetry, providing a cohesive look.

In conclusion, the Zanussi ZI 428 D stands out as a reliable and efficient choice for consumers seeking a high-quality built-in refrigerator. With its spacious design, advanced cooling technologies, energy efficiency, and user-friendly features, it is an ideal addition to any modern kitchen, meeting the needs of today's consumers while delivering exceptional performance.