Zanussi Z 52/6 W manual Installation, Positioning, Shelf holders

Page 14

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIANCE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Positioning

This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance.

The following table shows which ambient temperature is correct for each climate classification:

SN +10°C to + 32°C

N +16°C to + 32°C

ST +18°C to + 38°C

T +18°C to + 43°C

It should be located in a dry atmosphere, out of direct sunlight and away from extreme temperature e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse, where the temperatures may fall below 10°C (50°F). If these temperatures are exceeded i.e. colder or warmer, then the appliance may not operate correctly.

You should also ensure that air can circulate freely around the back and the top of the cabinet. There must also be at least 100 mm (4”) distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B).

There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. The back of the cabinet may be placed close to the wall but must not touch it. DO NOT install in places with restricted ventilation.

Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers (see figure).

Shelf holders

Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation.

To remove them proceed as follows:

Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions on “Door reversal directions” paragraph.

Important

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

100 mm

 

A

B

10 mm

10 mm

NP005

 

D200

 

 

A

 

B

14

Image 14
Contents Refrigerator Freezer Important Safety Information InstallationContents Description of the Appliance Operation Fresh food refrigeration ThawingMaking ice cubes Freezing Calendar Movable shelvesPositioning the door shelves Hints and Tips Energy Saving AdviceEvent of a Power Failure Normal Operating SoundsExternal cleaning Maintenance and CleaningInternal cleaning When the appliance is not in use Changing the light bulbFreezer Symptom Solution Something not WorkingService and Spare Parts 9 9 2Technical Specifications NET CapacityShelf holders InstallationPositioning Electrical connections Green and Yellow Earth Blue- Neutral Brown- LiveRear spacers Door reversalPage Page Page Electrolux plc