Change of door opening direction

Should the setting-up place or handling demand it, door- opening direction can be refitted from right-handed to left- handed.

Appliances on the market are right-handed.

Following operations are to be done on the basis of figures and explanations:

To perform the operations listed below it is recommended to ask another person for help who safely can keep the doors while performing the operations.

Disconnect the appliance from the electricity supply.

Open the doors and dismount the double door hinge (a, b) by removing the screws (2 pieces) (c). (fig.2)

Take off the double door hinge (a, b, c) by gradually removing it from the cabinet, slightly tilting both doors. Do not forget to remove the plastic spacer (b) under the hinge. (fig.2)

Take off the refrigerator door by pulling it slightly downwards.

Take of the freezer door by pulling it slightly upwards.

Remove the plug on the upper side of the refrigerator door and put it to the other side.

Remove the plug on the upper side of the freezer door and put it to the other side.

Unscrew the top door hinge pin (d) of the refrigerator then screw it back on the other side. (fig.1)

Remove the plugs (u) at the bottom of the appliance. (fig.3)

Remove the lower hinge (e) by removing its screws (s) and mount it on the other side. (fig.3)

Unmount the lower hinge pin (f) and its washer (h) and mount them into the other hole of the lower hinge. (fig.3)

Replace the plugs (u) on the other side.

Remove the covering nails (3 pieces) (n, k) of the double door holder on the left side and put them to the other side. (fig.2)

Fit the pin of the double door hinge (m) into the left drill of the freezer door. (fig.2)

Fit the freezer door to the lower door hinge pin (f). (fig.3)

Fit the refrigerator door to the upper door hinge pin (d) then slightly tilting both doors fit the pin of the double door hinge (m) into the left drill of the refrigerator door.

Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). Do not forget to replace the plastic spacer (b) under the hinge. Be careful that the door edges are parallel with the edge of the mantle.

Put the appliance to its place, set it level, and apply voltage to it.

In case you do not want to perform the procedures above, call the nearest brand-mark service.

Technicians will accomplish the refitting expertly for charge.

fig. 1.

fig. 2.

fig. 3.