Door reversal directions
1.Disconnect from the electricity supply.
2.Gently lay the fridge/freezer on its back with the top held away from the floor by
3.Remove the ventilation grill (D).
4.Remove the plug (F) from the ventilation grill (D) and replace it on the opposite side.
5.Unscrew the bottom hinge (E).
6.Remove the freezer door by releasing it from the middle hinge (H).
7.Unscrew the middle hinge.
8.Remove the fridge door by releasing it from the top hinge pin (A).
9.Remove the pin and the washer (A+B) from the top hinge (C), then mount these on the side, after having removed the small plugs (I) which should then be fitted on the opposite side.
10.Refit the fridge door and replace the middle hinge to the left hand side.
11.Replace the door and bottom hinge (E) on the opposite side.
12.Refit the grill (D) to the base of the product.
The doors can be aligned by adjusting both the middle hinge and the top hinges.
The middle hinge can be adjusted horizontally, after having slackened the two screws with a screwdriver.
The top hinge is adjusted by slackening the nut with a 10 mm spanner and then proceeding as shown in the figure.
Important
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
E | F |
| |
F |
|
| F |
D |
|
F |
|
H |
|
| C |
| B |
| A |
PR19 |
|
I |
|
I |
|
I |
|
20 | Printed on recycled paper |
|