Grizzly G0484 owner manual Inventory Figure Qty, Hex Wrenches, 4, 5, 6 mm

Inventory Inventory Clean Up Clean Up

After all the parts have been removed from the crate, you should have the following items with your machine:

Inventory: (Figure 3)		Qty
A.	Downfeed Handles	3
B.	Face Mill Assembly R8	1
C.	Adapter R8 - JT3	1
D.	Headstock Elevation Crank	1
E.	Wrench 24mm	1
F.	Hex Wrenches, 4, 5, 6 mm	1 Ea
G.	Handwheels	2
H.	Chuck 1–16mm JT3	1
I.	Chuck Key	1
J.	Handwheel Handles	2

The unpainted surfaces are coated with a waxy oil to prevent corrosion during shipment. Remove this protective coating with a solvent cleaner or degreaser, such as shown in Figure 4. For thor- ough cleaning, some parts must be removed.

For optimum performance, clean all moving parts or sliding contact surfaces. Avoid chlo- rine-based solvents, such as acetone or brake parts cleaner that may damage painted surfac- es. Always follow the manufacturer’s instructions when using any type of cleaning product.

Gasoline and petroleum products have low flash

A

B

C

D

H

points and can explode or cause fire if used to clean machinery. DO NOT use these products to clean the machinery.

E

F

G

I

Many cleaning solvents are toxic if inhaled. Minimize your risk by only using these products in a

J

Figure 3. Model G0484 inventory.

NOTICE

Some hardware/fasteners on the inventory list may arrive pre-installed. Check mount- ing locations before assuming that any items from the inventory list are missing.

If any nonproprietary parts are missing (e.g. a nut or a washer), we will gladly replace them; or for the sake of expediency, replacements can be obtained at your local hardware store.

G0484 Gear Head Mill/Drill

well ventilated area.

G2544—Solvent Cleaner & Degreaser

A great product for removing the waxy shipping grease from your machine during clean up.

Figure 4. Cleaner/degreaser available from

Grizzly.

-11-