Harbor Freight Tools 99599 manual Unpacking, Cleaning, Assembly For 99598 Meat Grinder

Page 6

Unpacking

When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

Cleaning

Read the entire Important Safeguards section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

To prevent serious injury

from accidental operation or electric shock:

Before cleaning appliance, make sure the appliance’s switch is turned off, the cord is unplugged, and the unit has cooled completely.

Do not immerse motor/heating element, cord, or plug in water or any other liquid.

1.To prevent foodborne illness, wash the non-electrical parts of the unit be- fore assembly in warm, soapy water, taking care to rinse completely.

2.Dry with a soft cloth. Wipe the motor/ heating element housing with a soft clean cloth or sponge.

3.Allow unit to dry completely before assembly or use.

4.After washing and drying, apply a small amount of salad oil (not includ-

ed) to Cutting Plates to keep them lubricated.

5.WARNING! Do not use bleach, thin- ners or benzines during clean. These will damage or discolor Meat Grinder.

Assembly

(For 99598 Meat Grinder)

Read the entire Important Safeguards section at the beginning of this manual including all text under subheadings therein before set up or use of this product.

To prevent serious injury

from accidental operation or electric shock:

Before appliance assembly or adjustment, make sure the appliance’s switch is turned off, the cord is unplugged, and the unit has cooled completely.

Note: For additional information regarding the parts listed in the following pages, refer to the 99598 Assembly Diagram on pages 10 and 11 of this manual.

1.Slide Head (12) into Housing Open- ing (15). While holding Head, place Locking Knob (22) into slot on Left Motor Housing (21).

2.Turn Locking Knob clockwise until tight and Head is fastened securely to housing.

3.Twist Feed Screw (100) long-end first into Head. Continue twisting until

Feed Screw fastened into housing.

SKU 99598/99599 For technical questions, please call 1-800-444-3353.

Page 6

Image 6
Contents Cleaning, Assembly, And Operation Instructions Model For technical questions or replacement parts, please callSave This Manual Electrical Safety Power Cord SafetyFoodborne Illness Safety Specifications For Model Cleaning Assembly For 99598 Meat GrinderUnpacking Assembly For 99599 Meat Grinder Operation For 99598 Meat GrinderOperation For 99598 Meat Grinder Maintenance InspectionParts List Part Description ’tyAssembly Diagram PCB Assembly Diagram