Hunter Fan 83003 manual D11, D12, D13, D15, Existing Construction accessible only from below

Page 15

Existing Construction – accessible only from below

D11	EXISTING FAN

D12

F

Remove an existing fan and check to make sure the open-	Move the housing into position above the ceiling.
ing is large enough to accommodate the new motor hous-
ing (9”x 9.75”).

D13

Route wires through strain relief.

D14

2

1

Attach existing ducting to duct connector. Tape joints.

If ducting does not fit securely,

an adapter may need to be purchased.

D15

F

Install the housing flush with the sheetrock and secure by

tightening the pre-loaded screws into the joist.

41953-01 3/29/2006

HF0023_EngS_3.29.06.indd 15

15

3/29/06 9:24:35 AM

Image 15

Contents Installation I d e Preventative Maintenance X2 D Before InstallationRemove the motor/blower from the housing A12 A15 A14A18 A19A21 A22 B15 B11B12 B13B17 B19B20 B26 B27 B22B23 B24C14 Existing Construction accessible from aboveC11 C13 C12C17 C15C16C21 C22C23 C25 C26 C28C29 D13 Existing Construction accessible only from belowD11 D12D16 D17 D18D19 D22 D23Attaching the Grille Screw glass dome into position Solution Trouble ShootingLimited Warranty WarrantyÍ a S t a l a c i ó n DesdePrecaución Verifique todos los Antes de la instalaciónRetire el motor/soplador del alojamiento Construcción nueva fijación a la viga Tienda los cables a través del manguito de Alivio de tension Vaya al paso A21De pulg Construcción nueva suspendido entre vigasApriete los tornillos B23 B26Construcción existente accesible desde arriba SIN Ventilador ExistenteTaladre un agujero en el centro de cada perfil Apriete los tornillos del aliviador de tensiones Vaya al paso En la página 37 para Fijar la rejilla Construcción existente accesible sólo desde abajo D20 Fijación de la rejilla Alinee la pantalla y levante Solución Solución de problemasGarantía Limitada Garantía