Zanussi ZOB 160 manual Technical Data, Electrical Connection, Dimensions of the oven cavity

Technical Data

The oven must be installed according to the instructions supplied.

This oven must be installed by qualified personnel to the relevant British Standards.

Heating element ratings		Dimensions of recess
Top element	800 W	Height	undertop	593 mm
Bottom element	1,000 W
			in column	580 mm
Oven elements (total)	1,800 W
		Width		560 mm
Inner Grill element	1,650 W
		Depth		550 mm
Full Grill element	2,450 W	Dimensions of the oven cavity
Oven Light	25 W
Total Rating	2,500 W	Height		335 mm
Supply voltage (50 Hz)	230 V	Width		405 mm
		Depth		410 mm
		Oven capacity		56 litres

Electrical Connection

The oven is designed to be connected to 230 V (50Hz) electricity supply.

The oven has an easily accessible terminal block which is marked as follows:

Letter L		-	Live terminal
Letter N		-	Neutral terminal
	or E	-	Earth terminal

THIS OVEN MUST BE EARTHED

It is necessary that you install a double pole switch between the oven and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current rules.

The switch must not break the yellow and green earth cable at any point.

The yellow and green earth cable should be 2-3 cm. longer than the other cables.

The cable used to connect the oven to the electrical supply must comply to the specifications given below.

For Uk use only

Connection	Min. size	Cable / flex	Fuse
via	Cable/flex	type
• Cooker	2.5 mm2	PVC/PVC	20 A
Control		twin and
Circuit		earth

I mmmportant

After installation and connecting, the cable must be placed so that it cannot at any point reach a temperatu- re of more than 50°C above the ambient temperature.

Before the oven is connected, check that the main fuse and the domestic installation can support the load; and that the power supply is properly earthed.

The manufacturer disclaims any responsibility should these safety measures not be carried out.

For Europe use only

Min. size Cable/flex	Cable / flex type	Fuse
2.5 mm2	H07 RN-F, H05 RN-F,	15 A
	H05 RR-F, H05 VV-F,
	H05 V2V2-F (T90),
	H05 BB-F

13