Five Star Ranges FSH361-SS, FSH361-WH, FSH361-BL, FSH301-WH, FSH301-SS Prepare the Hood, Option

Page 8

PREPARE THE HOOD

1.Using a Phillips #2 or a Robertson #2 screwdriver, unscrew the hood from the bottom of crate. Refer to figure to the right to locate all 4 screws. Discard these screws and remove hood from wood pallet.

HR0002

OPTION

A Backsplash is available (see page 5 for more details). This backsplash must be installed before the hood shell because the hood shell covers the backsplash top mounting screws. In order to be able to install the backsplash, make sure you have at least 18” (457 mm) clearance between bottom of hood and range control panel or cooktop. (Refer to instructions included with backsplash.)

2.Measure and mark a level line on wall above cooktop location for the wood mounting strip (see illustrations to the right and under step 2 on page 7). Use #10-2” flat head screws (included in the parts bag) to secure the mounting strip to the drywall. Make sure to hit the wall studs.

CAUTION: Due to the weight of this hood,

!ensure that the wood strip is attached to all of the available wall studs (2 studs minimum for the 30hood, more as hood width increases);

not into drywall alone.

3

4

1

2

7

1.Drywall

2.Wood Mounting Strip

3.Flat Head Screw

4.Wall Anchor Location

5.Outline of the Back of the Hood

6.Wall Studs

8

Image 8
Contents Range Hood Table of Contents WarrantySafety Instructions To Reduce the Risk of a Range TOP Grease FireOperation Cleaning Heat SentrytmTools Needed for Hood Installation Parts Included with HoodParts not Included with Hood Optional PartsFivestar Range Hood System Model 332HModel Model ½’’ x 18 ½’’ To 10’’ Rd., HorizPrepare the Hood Location Typical DuctworkPrepare the Hood OptionInstall the Hood Warranty Safety OperationConnect the Wiring Wiring DiagramFinalize the Installation Refer to page 5 for ordering informationInstall Filters Service Parts Description