board, etc.). If the screws and screw anchors are provided with the product, check that they are suitable for the type of wall on which the hood is to be fixed.
• FIXINGTHE DECORATIVETELESCOPIC FLUE
Arrange the electrical power supply within the dimensions of the decorative flue. If your appliance is to be installed in the ducting version or in the version with external motor, prepare the air exhaust opening. Adjust the width of the support bracket of the upper flue (Fig.4).Then fix it to the ceiling using the screws A (Fig.4) in such a way that it is in line with your hood and respecting the distance from the ceiling indicated in Fig.3. Connect the flange C to the air exhaust hole using a connection pipe (Fig.5). Insert the upper flue into the lower flue. Fix the lower flue to the hood using the screws B provided (Fig.5), extract the upper flue up to the bracket and fix it with the screws B (Fig.4).
USE
•If the apparatus is equipped with the following controls (fig.6A): A = OFF
B = SPEED I C = SPEED II D = SPEED III E = LIGHT
•If the apparatus is equipped with the following controls (fig.6B):
A = LIGHT
B = OFF/SPEED I C = SPEED II
D = SPEED III
E = AUTOMATIC STOP TIMER – 15 minutes
F = FILTER SATURATION RESET LIGHT
When the “filter saturation” light flashes or comes on without flashing, the
•If the apparatus is equipped with the following controls (fig.6C):
A = LIGHT B = OFF
C = SPEED I D = SPEED II E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes
•If your appliance does have the INTENSIVE speed function, press key E for two seconds and it will be activated for 10 minutes after which it will return to the previously set speed. When the function is active the LED flashes.To interrupt it before the 10 minutes have
- 9 -