Zanussi DCS 14 W, DCS 14 S manual Event of a fault, Fault Check

Fault

Check

The machine will not start.

■ Is the door closed properly?

■ Have you pressed the ON/OFF button?

■ Is there power to the machine?

■ Has the fuse blown? (Start with fuse in electrical plug).

■ Have you set the programme control knob properly?

■ Is the water tap turned on?

The machine is not filling with water.

■ Is the water tap turned on?

■ Has your domestic water supply been cut off temporarily?

■ Is the water intake hose kinked or blocked?

■ Is the filter inside the intake hose blocked?

■ Is the water pressure too low?

The machine will not drain.

■ Did you open the door before the light went out and the

cycle ended?

■ Is the drain hose kinked?

■ Is the sink drain blocked?

Dishes not washed satisfactorily.

■ Are the baskets too full?

■ Have the dishes not been arranged properly?

■ Has anything prevented the spray arm from rotating?

■ Are the spray arm holes clogged?

■ Are the filters clogged?

■ Are the filters in position?

■ Did you use enough detergent?

■ Is the detergent old or has gone hard?

■ Is the salt container cap properly closed?

■ Is the washing programme selected too gentle?

■ Is the rinse aid dispenser empty?

Visible lime deposits or white film on

■ Is the salt container empty or is the water softener not

the dishes.

correctly adjusted?

■ Is the rinse aid dispenser adjusted to too low dosage?

The machine is noisy.

■ Are the dishes rattling against each other?

■ Is the spray arm knocking against the dishes?

The dishes are not quite dry.

■ Is the rinse aid dispenser empty?

■ Have the dishes been left too long inside the machine?

The door is difficult to close.

■ Is the dishwasher level?