Operating sequence
1. Check the filters
Ensure they are clean and properly positioned (see "Maintenance and cleaning").
2. Press the
The
3. Check that there is rinse aid and salt
The corresponding indicator lights will illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5.Ensure that the spray arms can rotate freely
6.Measure out detergent
Add the required amount of detergent into the dispenser according to the recommended quantity given in the Washing programmes chart.
Close the detergent dispenser lid.
7. Close the dishwasher door
8a. Setting and starting the programme without DELAY START
Press the push button corresponding to the required programme: the indicator light corresponding to the programme illuminates and the phase indicator lights for that programme start flashing.
The start of the programme will occur after about 6 seconds from the last pressure of a programme push button, in this time it is possible to change programme simply pressing the push button of another programme. Once the programme has started the phase indicator lights will turn off except for the phase under way.
It is possible to interrupt the programme by:
●opening the door
●pressing the
Close the door again or press the
8b. Setting and starting the programme with DELAY START
The setting of the delay start occurs before selecting the programme.
Press the DELAY START push button and selected the desired time (3, 6 or 9 hours) until the indicator light corresponding to the chosen hours flashes.
Press the push button corresponding to the required programme: the indicator light corresponding to the programme illuminates and the phase indicator lights for that programme start flashing.
The start of the countdown will occur after about 6 seconds from the last pressure of a programme push button.
The countdown will decrease with step of 3 hours and you are informed of this by the indicator lights of the hours.
During the countdown the only indicator lights illuminated are the programme light and the light of the number of hours to the start of the programme.
Once the delayed time has elapsed the programme will start automatically.
It is possible to stop a countdown in progress or before it starts, simply pressing the DELAY START push button until the indicator lights of the hours are off.
9. To cancel a programme in progress
A programme in progress can be cancelled at any time. Press for about 3 seconds the push button of the running programme until all indicator lights are off.
Only the
It is now possible to select a new washing programme.
10. At the end of the washing programme
The dishwasher will automatically stop and the phase indicator light end of programme will come on.
The indicator light of the programme just ended will remain on.
The dishwasher has finished the programme only when
the end of programmeindicator light is illuminated. If you do not wait for the end of the programme it will not
be possible to start a new programme if first you do not cancel the previous.
(For instructions on how to cancel a programme see point 9)
Switch off the dishwasher by pressing the
Wait a few minutes before removing the dishes; in this way they will be cooler and drying will be improved. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
Important!
In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops.
Care must be taken if the door is opened during the hot phase or immediately after a programme has finished, as steam may escape.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
11