Zanussi ZDF 222 manual Inlet hose, Drain hose

Page 22

WARNING!

Only use, for connection to the water mains, new hose-set; old hose-set must not be reused.

CAUTION!

If the machine is connected to new pipes or pipes which have not been used for a long time,

Inlet hose

you should run the water for a few minutes be- fore connecting the inlet hose.

Connect the inlet hose to a water tap with an external thread of 3/4”.

The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks.

Drain hose

Connect drain hose to the sink. Secure it with the supplied hose clamp.

Required height: 30 to 100 cm above bottom of the dishwasher.

Ensure that the hoses are not kinked, crushed or en- tangled.

When connecting the drain hose to an under sink trap spigot, the entire plastic membrane (A) must be removed. Fail- ure to remove all the mem- brane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents
Dishwasher ZDF Contents Child safety Safety informationGeneral safety Correct useInstallation Control panelStarting the washing programme Washing programmes When using tablets that integrate rinse aid and detergent First useWater hardness Mmol/l Set the water softenerUse of salt Setting the water softener electronically see table Setting the water softener manually see tableFilling with dishwasher salt Only before filling with Adjusting the dosage of rinse aid Filling with rinse aidLoading cutlery and dishes Are of limited suitabilityMaximum height of the dishes Upper basket Adjusting the height of the upper basketLower basket Use of detergent To move to the higher position proceed as followsCleaning the filters Care and cleaningUnloading the dishwasher Internal cleaning Cleaning the spray armsExternal cleaning Prolonged periods of non- operationMoving the machine Frost precautionsEnvironmental concerns Packaging material Possible cause and solution Fault code and malfunction Something not working Wash results are not satisfactory Consumption values Technical dataHints for test institutes Full load 12 standard place settings InstallationWater connection Inlet hose Drain hoseElectrical connection Fitting under a counterGuarantee/Customer Service LevellingAddress for our consumer services depart- ment European Guarantee LuxembourgPage Page Page Page Page 156994260-00-30052007 Subject to change without notice
Top Page Image Contents