Operating sequence
In this fully integrated appliance the controls are located on the top of the door. When selecting a programme, the door needs to be open.
1.Check that the baskets have been loaded correctly and that the spray arms can rotate freely
2.Turn on the water tap
3.Set and start of the programme
Turn the programme selector dial clockwise until the letter of the programme you wish to select corresponds with the programme marker on the control panel. Depress the On/Off push button and close the door. The machine will start.
4.Interrupting a washing programme in progress
Interrupt a washing programme in progress ONLY if it’s absolutely necessary.
Attention! Hot steam may escape when the door is opened. Open the door carefully.
Open the dishwasher door; the programme will stop. Close the door; the programme will start from the point in which it was interrupted.
5. End of the washing programme
The dishwasher will automatically stop.
Open the door and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved.
Switch off the dishwasher by pressing the On/Off push button, the On/Off indicator light turns off.
6. Unloading the dishwasher
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance.
Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one.
Water may appear on the sides and door of the dishwasher as the stainless steel will eventually become cooler than the dishes.
When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off.
12