Zanussi ZDT 5052 manual Something not working

Something not working

Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an enginee						r.
The dishwasher is fitted	with a number of alarm systems which can help you to quickly determine the cause of any problems.
If the dishwasher will not start or stops during operation, all push buttons are inoperative except for the On/Off push button,						the
On/Off indicator light is off, one or more of		the	programme	indicator	lights start flashing, open the door and press the On/Off	push
button to switch off the	dishwasher and carry out	the	following	suggested	corrective actions listed below.

Once the checks have been carried out switch on the dishwasher and start a washing programme, if the fault code reappears contact your local Service Force Centre.

Important: If you call out an engineer to a fault listed below or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is in guarantee.

Symptom	Fault code	Solution
The machine will not start			● The door has not been properly closed.
			● The plug is not properly inserted in the power socket.
			● There is a power failure.
The machine does not fill	RINSE AND HOLD		● Ensure the water tap is open.
with water	programme		● Ensure the mains water supply has not been cut off.
	indicator light is		● The inlet	hose may be squashed or bent. Reposition the hose.
	flashes		● The inlet hose may be blocked. Switch off the water supply
			and clean the filter.
The dishwasher will not drain	QUICK programme		● The drain hose may be squashed or bent. Reposition the
	indicator light is		hose.
	flashing		● The sink may be blocked. Clear any blockages.
			● The drain hose extension is not correct. Follow the instructions
			for connecting to the waste.
			● There is no vent in the end of the drain hose.
The filters are clogged	INTENSIVE		● Clean the filters (refer to "Maintenance and cleaning").
	programme indicator
	light is flashing
General	Other programme		● Switch off the dishwasher. Switch it back on and start the
	indicator lights are		programme. If the alarm reappears, call the local Service
	flashing		Force Centre.
The machine is noisy			● Dishes are rattling against each other, refer to “Loading
			your machine”.
			● The spray arms are knocking against the dishes. Refer
			to "Loading your machine".
The door is difficult to close			● The dishwasher is not level, or not properly built-in.
Visible lime deposits or			● Check that there is salt and that the salt cap is tight.
white film on the dishes			● Check that the right level of the water softener is setted.
The dishes are not quite dry			● The rinse aid has run out or too little is being used		.
The dishes are not clean			● The baskets are too full.
(poor wash)			● The dishes have not been arranged properly.
			● The spray arms do not rotate
			● The spray arms are clogged.
			● The filters are not in the correct position.
			● Not enough detergent has been used or it is unsuitable.
			● The detergent is old or has gone hard.
			● The salt container cap is not properly closed.
			● The washing programme selected is too gentle.

12