SECTION 8: WHEN YOU ARE FINISHED USING SOUNDBRIDGE
When you are finished playing music and using your SoundBridge altogether, just press the Standby [Ѷ] button on your remote. In Standby mode, SoundBridge can display the date and time or a blank display, depending on your preference. (See page 40 for more information about setting these preferences.)
If you were playing Internet radio when you pressed Standby, then pressing Standby again will resume playback of that station. Otherwise it will return you to the music library to which you were most recently connected.
If you plan to disconnect SoundBridge from AC power after you are done using it, be sure to press the Standby button first. This logs you out of the music server software running on your computer.
Note : Wait approximately 10 seconds after pressing Standby [Ѷ] before unplugging SoundBridge; this gives SoundBridge time to flush its settings for a clean reboot.
Hint : If you unplug the SoundBridge from AC power five times without pressing Standby [Ѷ] on your remote first, iTunes may lock you out of connecting to the server. That’s because iTunes allows a maximum of five users to connect at one time, and if you don’t put SoundBridge into standby mode first, iTunes may believe you are still connected. To restore your access to the iTunes server, close iTunes and then restart it. You should then have no trouble connecting to the iTunes server as before.
42 | Section 8: When You Are Finished Using Soundbridge |