Zanussi ZGF 780 IT manual Operation, Lighting the burners

Operation

Hob burners control knobs

The symbols on the knobs mean that :

zthere is no gas supply (“off” position) there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan support.

)To light a burner:

z turn the relevant knob anti-clockwise to

maximum position (), then push it down to ignite the burner.

z Upon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" (see Fig.1 - letter D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted.

z Then adjust the flame as required.

If the burner accidentally goes out, turn the control knob to the "off" position and wait for at least 1 minute before trying to light the burner again.

If you cannot light the flame even after several attempts, check the "cap" (see Fig.1 - letter A) and the"crown" (see Fig.1 - letter B) are in the correct position.

)To switch off a burner:

z To put the flame out, turn the knob to the symbol ( z ).

Fig. 1

Triple crown burner

A

B

D

C

A - Burner cap

B - Burner crown

C - Ignition electrode

D - Thermocouple

8