Connections

The Tube Vitalizer is fitted with both XLR-connectors and TRS stereo jacks for balanced operation, though the jacks may be used with unbalanced connections simply by plugging in mono jack-plugs. The level difference that normally occurs when a balanced input or output is used unbalanced is automatically compensated for.

Should the need arise to use the XLR connectors in an unba- lanced system, pin 3 of the XLRs should be grounded. Inserting a mono jack also unbalances the XLRs.

Both output stages operate in parallel, so it is possible to connect two different destination units simultaneously, for example to record to two different media at the same time or split the output between a mixer and effects processor. However, only one type of input (jack or XLR) should be connected at a time – the Tube Vitalizer is not intended to be used as a mixer!

To ensure optimal signal quality, SPL has developed a new hybrid-component balanced input/output stage using all laser- trimmed resistors with a tolerance of 0.01%. This approach has resulted in an exceptionally high CCMR (common mode rejec- tion); 100 dB at 1kHz and 80 dB at 10 kHz.

As a precaution, before connecting the Tube Vitalizer switch off the power to the unit and to all connected units.

Pin wiring: Stereo Jack plug

Tip=Hot(+) Ring=Cold(-) Sleeve=GND

Pin wiring: XLR connectors

13 2 1=GND 2=Hot(+) 3=Cold(-)

Other rear panel connections and switches:

•Voltage selector: 220-240V / 50 Hz or 100-120 V / 60 Hz

•CSA/UL approved 3-pole power plug

•GND-Lift switch

TUBE VITALIZER