Door Reversal

Before carrying out the operations described below, pull out the mains plug from the wall socket.

You will need a Philips screwdriver (cross headed) and a normal screwdriver (slot headed).

To carry out this reversal go through the following steps:

1.Gently lay the appliance on its back with the top held away from the floor by 5-8 cm (2-3 inches) of packing.

2.Remove the bottom door hinge (5).

3.Remove the door (4) by opening it and pulling it gently downwards to remove it from the top hinge pin (2).

4.Unscrew the top hinge pin (2) from the top hinge

(1) and replace it in the opposite hole on the left hand side.

5.Unscrew the foot at the base (6) of the appliance and refit it on the opposite side.

6.Refit the door and the bottom hinge to the left hand side.

When the bottom hinge is screwed in, a certain amount of force is exerted on the screws.

It is therefore advisable to lubricate the screw tips before starting this operation.

Important

After completion of the door reversal opera- tion, verify that the door gasket is sealing onto the cabinet.