Zanussi ZEC 30 manual D471

Page 8

Once the top of the panel has been correctly positioned, fix it through the holes in the bottom bracket, without tightening the screws (Fig. 10).

Fig. 10

D471

Check the position again by slackening the screws and pins then, once the best position has been obtained, fully tighten all the fixings.

Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket.

Fig. 11

D

D472

Once the door has ben correctly aligned, tighten the holding nuts on the fixing brackets and attach the appliance to the adjacent units and the bottom of the work surface (Fig. 12).

Fig. 12

D517

For a correct installation operation if the base plate is more than 100 mm (for cavity height 820 mm) or more than 150 mm (for cavity height 870 mm) you must cut out the plate as shown in Fig. 13.

Fig. 13

D593

8

Image 8
Contents Freezer Contents Technical Specifications09/96 Installation ConservationElectrical connections Location Door reversibilityFitting a decorative door panel D471 Your Appliance Frozen food storage OperationControls See Fig Helpful hints when buying food Ice makingThawing Freezing fresh foodNormal sound DefrostingStarting Health and Safety Guidelines Maintenance and CleaningInternal cleaning When the appliance is not in useWhat Happens if Something Goes WRONG? Exclusions Zanussi standard guarantee conditionsPeace of Mind for Twentyfour Months