Zanussi ZEUT 6245 manual Something Not Working, Problem Possible Cause Solution

)To carry out complete defrosting:

1.Disconnect the appliance from the electrical supply. If the plug is inaccessible turn the thermostat control knob to „0“.

2.Remove any stored food, wrap in several layers of newspaper and store in a cool place.

3.Leave the door open.

4.Carefully draw the plastic drain spout out of the lower part of the appliance according to the direction of the arrow and place a tray of a suitable size in the position shown.

5.During defrosting, push the defrost water towards the edge of the cooling plates using a dry cloth or a sponge. It will be collected at the bottom of the appliance, from where it can be diverted into the tray and then disposed of.

6.To accelerate the defrosting process place a bowl of hot (not boiling) water inside the freezer and close the door.

7.When defrosting is completed, dry the interior thoroughly, replace the drain spout and close the door.

8.Turn the thermostat control knob back to a medium setting and leave to run for at least 4 hours with the 'fast freeze' switch on.

9.Replace the previously removed food.

Important

A temperature rise of the frozen food packs during defrosting may shorten their safe storage life.

Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair.

Something Not Working

If the appliance is not working correctly, please carry out the following checks before contacting your local Zanussi Service Force Centre.

Problem	Possible Cause	Solution
No power to the	No power at the socket.	Check there is power at the socket.
appliance	There is a power cut.	Check there is not a power cut by checking the
		household lights.
	The fuse has blown.	Check the fuse has not blown.
	Thermostat control is set at „0“.	Check the thermostat setting.
The temperature in the	The appliance is located in an unsuitable position.	Check the ambient temperature is within the
appliance is too high		appliances operating limits of 16 °C to 32 °C.
	The thermostat control is set too low.	Check that the thermostat control knob is turned to
		the correct setting relative to ambient conditions.
The temperature in the	The thermostat control is set too high.	Set the thermostat control knob to a lower
appliance is too low		position.
Excessive frost and ice	The door has been left open.	Check the door has not been left open.
has built up	Something is obstructing the door.	Check nothing is preventing the door from closing.
	The door gasket is dirty.	Check the door gasket is intact and clean.
The appliance is noisy.	The appliance is not level.	Check if the appliance stands stable (all four feet
		should be on the floor).

If after the above checks your appliance still does not operate correctly, contact your local Zanussi Service Force Centre.

Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.

In-guarantee customers should ensure that the above checks have been made, as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

10