If installation next to a source of heat is unavoidable, the following minimum clearances must be maintained at the sides of the appliance:
for electric cookers | 3 cm |
for oil and coal fired ranges | 30 cm |
Ventilation Requirements
The appliance must have adequate ventilation to ensure correct operation.
Diagram shows the ventilation requirements when installed:
A:Under a worktop, or cupboard.
B:When freestanding
Leveling
The appliance must be level. Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance.
Door Reversal
If required the opening direction of the door can be changed as follows:
To reverse the bottom hinge assembly proceed as follows:
Disconnect the appliance from the electricity supply.
Tilt the appliance backwards, resting the top edge of the appliance on a stool or something similar.
Unscrew the adjustable feet situated on both sides at the front (2 pieces). Remove the lower door hinge plate by unscrewing the 3 retaining screws.
Remove the hinge pin from the bottom of the door.
Slot the hinge pin into the hole in the hinge plate and relocate the hinge assembly to the opposite location and refit using the retaining screws.
Put the cabinet in the upright position.
13