Tricity Bendix BDW 60 manual Filling with salt, To fill

To select a different level ensure that the dishwasher is off and then proceed as follows:

1. Press	RINSE & HOLD			and	INTENSIVE	programme push
buttons simultaneously.
2. While keeping the programme push buttons						RINSE &
HOLD	and	INTENSIVE pressed switch on the dishwasher
by pressing the			MAINS ON		push button.
The	MAINS ON		indicator light comes on.
At the same time, the indicator lights of the						RINSE & HOLD
and	INTENSIVE push buttons start flashing.
3. Press the		RINSE & HOLD			push button, the indicator light of

Filling with salt

Only use salt specifically designed for use in dishwashers.

All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener.

Only fill with salt just before starting one of the washing programmes.

This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time, which may cause corrosion.

To fill:

1.To fill with salt, unscrew the cap of the salt container.

			SO527
the	INTENSIVE push button turns off, while the indicator
light	of the		RINSE & HOLD	push button remains fixed for
about	5	seconds, after this it starts flashing indicating the
current		level of the water softener.

The current level is indicated by the number of flashes

2.Pour 1 litre of water inside the container (this is necessary only

before filling with salt for the first time).

3.Using the funnel provided, pour in the salt until the container is full.

Do not worry if water over flows from the unit when filling with salt, this is quite normal.

4.Replace the cap making

sure that there is no trace of salt on the screw thread or on the gasket.

SALET

SAL

SALZ

SEL

SR06

SO528

made by the			RINSE & HOLD	indicator light, that alternates
5	seconds off with a number of flashes, this for about 60
seconds.
Example:
1 flash			= level 1
2	flashes	=	level 2
3	flashes	=	level 3
4	flashes	=	level 4
5	flashes	=	level 5

4. To change the level, press the		RINSE & HOLD
programme push button. Each time the push button is
pressed the level changes.
Example:
if the current level is 3, by pressing the		RINSE & HOLD
programme push button once, level 4 is selected.
if the current level is 5, by pressing the		RINSE & HOLD
programme push button once, level 1 is selected.
The RINSE & HOLD	indicator light remains off for about 5

seconds after which it starts flashing indicating the new level selected.

5.To memorise the new level, switch off the dishwasher by

pressing the MAINS ON push button.

5.Screw on the cap tightly.

The salt container will require topping up periodically.

You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished.

The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched

on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected.

5