Instructions for the Installer

Technical data

Model	TB 45 UF
Gross capacity (l)	117
Net capacity (l)	100
Width (mm)	550

Height (mm)	850

Depth (mm)	600
Energy consumption (kWh/day)	0.75
(kWh/year)	274
Energy class, according to EU Standards	B
Freezing capacity (kg/24h)	15
Rising time (h)	17
Rated power (W)	120
Weight (kg)	39

Installing the appliance

Transportation, unpacking

The appliance and the interior fitting are protected for transport.

Remove all packaging and any adhesive tape.

Any remnants of adhesive can be removed using white spirit.

After transportation the appliance must not be switched on for 2 hours. This is to allow the refrigerant to settle.

Cleaning

Clean the accessories and the inside of the appliance with warm water and bicarbonate of soda (5 ml to 0.5 litres of water). Rinse and dry thoroughly.

Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol.

Location

The appliance should be positioned in a well ventilated, dry room.

Energy use is affected by the ambient temperature. The appliance should therefore:

not be installed next to radiators, cookers or other sources of heat

only be installed at a location where the ambient temperature corresponds to the climate classification, for which the appliance is designed.

The climate classification can be found on the serial plate.

The following table shows which ambient temperature is correct for each climate classification:

Climate Classification Ambient Temperature

SN	+10 to +32 °C

N	+16 to +32 °C

ST	+18 to +38 °C