Freezer
The freezer compartment will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost reaches 1/4”.
During this operation it is not necessary to switch of the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to perform this operation when the appliance is empty.
For complete defrosting (once or twice a year) proceed as follows:
Turn the thermostat dial to the „OFF” position (O) or disconnect the appliance from the mains.
Remove any food from inside the freezer and fridge; wrap it in several sheets of newspaper and store in a cool, dry place.
Leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, lift the plug as shown in the figure..
Clean and dry thoroughly.
Replace the scraper in one of the drawers.
Reconnect the appliance to the mains or reset the thermostat to a functioning position.
After letting the appliance run for a least half an hour, replace the previously removed food into the compartment.
Important
A temperature rise of the frozen food packs during defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from the evaporator as this could damage the appliance beyond repair.
ΦTo Change the Light Bulb
1.Disconnect the appliance from the electrical supply or turn the thermostat to '0'.
2.Take the lamp cover off in the direction of the arrow and change the bulb. (Type of bulb: 230 V, 15 W, E 14 thread)
3.Replace the lamp cover and fixing screw.
Spare bulbs are available from your local Tricity Bendix Service Force Centre.
11