CLEANING BETWEEN THE OUTER AND INNER DOOR GLASS
The outer door glass is removable for cleaning.
TO REMOVE THE OUTER GLASS
1.Open the oven door slightly to gain access to the two cross head screws on the top of the oven door.
2.Loosen the two screws using a Pozidrive screwdriver.
3.Hold the door glass securely in place with one hand before removing the screws completely with the other hand.
4.Using both hands, gently tilt the top of the door glass towards you, lift slightly to disengage the locators from the two bottom brackets.
5.Clean the outer and inner glass using hot soapy water or Hob Brite cleaner may be used with care. DO NOT use Hob Brite on the Stainless Steel or painted finishes. DO NOT try to clean the foil which is inside the door. The foil is there to help keep the door cool, if it is damaged it will not work. Ensure that all parts are well rinsed and thoroughly dried before attempting to replace the outer door.
TO REPLACE THE OUTER GLASS
1.Holding the oven glass with both hands, gently place the locators into the holes of the brackets at the bottom of the oven door.
2.Push the top of the oven glass towards the oven door, ensuring the screw location holes line up.
3.Hold the glass in place with one hand and insert the cross head screws into the location holes with the other hand. Give the screws one turn to ensure the glass is secure.
4.Tighten the screws positively with a Pozidrive screwdriver before closing the oven door.
Do not attempt to use the oven without the glass being in place.
If the door glass panel becomes chipped or has deep scratches the glass will be weakened and must be replaced to prevent the possibility of the panel shattering. Please contact your local Service Force Centre who will be pleased to advise further.
TO CLEAN THE INNER GLASS DOOR PANELS
Clean the inner glass door panels using a soft cloth and hot water to which a little washing up liquid has been added. If the inner panel is heavily soiled, Hob Brite may be used. Do not use abrasive cleaning materials on the door glass. Ensure that all parts are well rinsed and thoroughly dried before attempting to replace the glass.
REPLACING THE OVEN LIGHT BULB
The type of bulb required is a 300°C 25 watt small Edison Screw. Part number 572 491
CAUTION: Disconnect the appliance from the electricity supply before replacing the bulb.
Open the door and remove the shelves to enable easy access to the oven light assembly. Insert a flat blade screwdriver between the oven side and glass which covers the bulb.
Support the glass with your hand and prise out sufficiently to release the glass cover. Unscrew the bulb in an anticlockwise direction until it is possible to remove the bulb with ease.
Fit the new bulb by turning in a clockwise direction until it is secure. Ensuring the indent to the flange is pointing to the rear of the oven, replace the glass by pushing it firmly into the hole to cover the bulb assembly.
Replace the shelves. Restore the electricity supply and adjust the time of day and clock as necessary.
28