•Refer to the serial plate for correct electrical rating. The power cord of the appliance is equipped with a
•If voltage varies by 10 percent or more, appliance performance may be affected. Operating the appliance with insufficient power can damage the motor. Such damage is not covered under the warranty. If you suspect your voltage is high or low, consult your power company for testing.
•To prevent the appliance from being turned off accidentally, do not plug the unit into an outlet controlled by a wall switch or pull cord.
•Do not pinch, knot, or bend the power cord in any manner.
Other Precautions
•Never unplug the appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the receptacle.
•To avoid electrical shock, unplug the appliance before cleaning.
Note: Turning the control to OFF turns off the compressor, but does not disconnect power to other electrical components.
Installation and Setup
Inspect for Damage
Inspect the underside of the cabinet and packaging for damage such as a fork truck can cause, or look for bent base members from dropping the cabinet. If hidden damage is found after uncrating, immediately call the delivery carrier and request an inspection. Retain all packaging and crating materials until the inspection is complete.
Uncrate and Set Up
1.Remove carton and all loose parts from inside of freezer.
2.Tip unit onto its back with the help of an assistant.
3.Remove and discard the two wood skids from bottom and the four (4) screws. See following illustration.
4.There are four casters in the caster kit. The pair of casters to be used in the rear, do not have brakes. Place one of these casters over one of the bolts in the rear. Place one of the locking nuts on the bolt to retain the caster. Tighten securely. Repeat to install the other rear caster.
5.Remove the two 3/8" hex head screws located in the upper corners of the base panel.Set the base panel aside.
6.To install the front casters, first put two short bolts through the rear
7.Reinstall the base panel.
8.Installation is now complete.
9.Tip up the unit with an assistant's help.
4