Frigidaire FGTR1845QF To level the cabinet using the front rollers, When reversing the door swing

INSTALLATION

NOTE

Raise the front of the refrigerator enough so the doors close freely when opened halfway. The refrigerator should slope ¼ inch to

½ inch from front-to-back. Then level the refrigerator from side-to-side.

4 Some models are equipped with an anti- tip bracket (Figure 4). Lower it clockwise until it contacts the floor.

some models

To level the cabinet using the front rollers:

1 Remove the toe grille.

2 Use a flat-blade screwdriver or ⅜ inch socket wrench to raise or lower the front rollers (Figure 2).

Raise

Figure 2 or

3Use adjustable wrench to adjust leveling screws. Lower the leveling screws on each side clockwise until they contact the floor

(Figure 3).

Lower

Anti-tip

Bracket

Figure 4 (some models)

WARNING

The anti-tip device must be installed according to the instructions in your Use & Care Manual. Failure to do so will result in injury.

WARNING

When reversing the door swing:

You MUST move the anti-tip bracket to align with the hinges of the door. Failure to do so will result in injury.

Raise

Figure 3

5