Frigidaire FFSC2323LE More about your Advanced Water Filter, Test & certification results

Page 20

CHANGING THE FILTER

More about your Advanced Water Filter

The PureSource UltraTM ice and water filter system is tested and certified to NSF/ANSI Standards 42 and 53 for the reduction

of claims specified on the performance data sheet.

The PureSource 3TM ice and water filter system is tested and certified to NSF/ANSI Standards 42 and 53 for the reduction

of claims specified on the performance data sheet.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Test & certification results:

Rated Capacity - 200 gallons/757 liters for

PureSource UltraTM and PureSource 3TM ice and water filter

Rated service flow - .50 gallons per minute

Operating Temp.: Min. 33°F, Max. 100°F

Maximum Rated Pressure - 100 pounds per square inch

Recommended Minimum Operating

Pressure: 30 pounds per square inch

To replace your PureSource 3TM water filter:

It is not necessary to turn the water supply off to change the filter. Be ready to wipe up any small amounts of water released during the filter replacement.

1 Turn Off the ice maker.

2Remove the filter by pushing on the end/ face of the filter.

3Slide the old water filter cartridge straight out of the housing and discard it.

4Unpackage the new filter cartridge. Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.

5Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector).

6Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal.

7After filling one glass of water, continue flushing the system for about four minutes.

8Turn On the ice maker.

9Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from “Red” to “Green,” the status has been reset.

20

Image 20
Contents Use &Care Important Safety Instructions Risk of child entrapment Proper Disposal of your Refrigerator or FreezerElectrical information Features AT a Glance Features may vary according to modelInstallation Toe Grille Installation and RemovalInstallation LocationDoor Opening Guidelines for final positioning of your refrigeratorDoor Removal Instructions Getting through narrow spacesTo remove the refrigerator top hinge cover To remove the refrigerator doorTo remove the freezer top hinge cover To remove the freezer doorHandle Installation Connecting the Water Supply Before Installing The Water Supply Line, You Will NeedTo Avoid Property Damage To Connect Water Supply Line To Ice Maker Inlet ValvePlastic Water Setting Cooling Temperatures Sabbath ModeControls User InterfaceFilter reset Fahrenheit to CelsiusStorage Features Chill Drawer some models Using the Ice Maker after Installation Automatic ICE & Water DispenserPriming the Water Supply System Ice Maker Operation & CareIce Maker/Dispenser Tips Turning the Side Mounted Ice Maker On and OffTurning the Rear Mounted Ice Maker On and Off Remove and empty the ice storage bin if Cleaning the Ice MakerTo clean the ice maker Changing the Filter More about your Advanced Water Filter Test & certification resultsTo replace your PureSource 3TM water filter PureSource UltraTM and PureSource 3TM ice and water filterNormal Operating Sounds and Sights Understanding the Sounds you may HearCare & Cleaning Protecting your investmentCare & Cleaning Tips Part What To Use Tips and PrecautionsBefore YOU Call Cleaning Dispenser Ice & Water Dispenser willWater has an Odd tasteCompressor Does not runRefrigerator Runs too muchMajor Appliance Warranty Exclusions This warranty does not cover the following