Installation

This Use & Care Manual provides specific operating instructions for your model. Use the refrigerator only as instructed in this Use & Care Manual. Before starting the refrigerator, follow these important first steps.

LOCATION

•Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an adapter plug.

•If possible, place the refrigerator out of direct sunlight and away from the range, dishwasher or other heat sources.

•The refrigerator must be installed on a floor that is level and strong enough to support a fully loaded refrigerator.

•Consider water supply availability for models equipped with an automatic ice maker.

INSTALLATION

Do Not install the refrigerator where the temperature will drop below 55°F (13°C) or rise above 110°F (43°C). The compressor will not be able to maintain proper temperatures inside the refrigerator.

Do Not block the toe grille on the lower front of your refrigerator. Sufficient air circulation is essential for the proper operation of your refrigerator.

Installation Clearances

•Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections:

Sides & Top --------------- 3/8” Back ------------------------ 1”

DOOR OPENING

NOTE: If your refrigerator is placed with the door hinge side against a wall, you may have to allow additional space so the door can be opened wider.

Your refrigerator should be positioned to allow easy access to a counter when removing food.

LEVELING

All four corners of your refrigerator must rest firmly on a solid floor.Your refrigerator is equipped with adjustable front rollers to help level your unit.

To Level Your Refrigerator:

1. Remove toe grille.

2.Use flat-blade screwdriver or 3/8” socket wrench to adjust front rollers.

NOTE: Raise the front of the refrigerator enough so the doors close freely when opened halfway. The refrigerator should slope ¼” to ½” from front-to-back. Then level the refrigerator from side to side.

WATER DISPENSER DRIP TRAY

The drip tray for your refrigerator’s water dispenser comes from the factory detached. Its removal also allows easy cleaning. To install the drip tray, fit it into the bottom of the dispenser bay and snap into place.