Frigidaire 318205115E Removing and Replacing the Oven Door, Special Door Care Instructions

Page 13

Hinge lever hook

Hinge support

Lock engaged for door removal

Figure 1

HINGE SLOT - Door removed

from the oven

Figure 2

Hinge lever

Lock in normal position

Figure 3

Care & Cleaning

Removing and Replacing the Oven Door

The door is heavy. For safe, temporary storage, lay the door flat with the inside of the door facing down.

To Remove Oven Door:

1.Open the door to the fully opened position.

2.Pull up the lock located on both hinge supports and engage it in the hinge lever hooks (Figure 1).You may have to apply a little downward pressure on the door to pull the locks fully over the hinge lever hooks.

3.Grab the door by the sides and pull the bottom of the door up and toward you to disengage the hinge supports. Keep pulling the bottom of the door toward you while rotating the top of the door toward the range to completely disen- gage the hinge levers (Figure 2).

4.To clean oven door, follow the instructions provided in the General Care & Cleaning table.

To Replace Oven Door:

1.Grab the door by the sides; place the hinge supports in the hinge slots. Open the door to the fully opened position.

2.Disengage the lock from the hinge lever hooks on both sides (Figure 3). Note: Make sure the hinge supports are fully engaged before unlocking the hinge levers.

3.Close the oven door.

Special Door Care Instructions

Most oven doors contain glass that can break.

Read the following recommendations:

1.Do not close the oven door until all the oven racks are fully in place.

2.Do not hit the glass with pots, pans, or any other object.

3.Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

Changing the Oven Light

On some models an interior oven light will turn automatically when the oven door is opened. The oven light may be turned on when the door is closed by using the oven light switch located on the control panel. On some models, the lamp is covered with a glass shield held in place by a wire holder. THE

GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.

To replace the light bulb:

CAUTION: BE SURE THE OVEN IS COOL.

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Replace bulb with 40-watt appliance bulb only.

4.For models with glass shield, press holder on one side to release glass shield, change bulb and be sure to replace the glass shield.

13

Image 13
Contents 318205115 0703 Rev. a Wall OvenProduct Registration Welcome & CongratulationsSerial Plate Location Important Safety Instructions Important Instructions for Using Your Oven Your Electric Wall Oven Features At a Glance Features At a GlanceSetting Oven Controls Before Setting Oven ControlsAir Circulation in the Oven Arranging Oven RacksOven Baking Cooking InformationsGrid Some models BroilingConvection Roasting some models Convection Cooking some modelsConvection notes Stainless Steel, Chrome Control Panel, Decorative Trim Care & CleaningOven Racks Oven DoorTo Set the Self-Clean Cycle Self-Cleaning some modelsAdhere to the following cleaning precautions What to Expect during CleaningCare and Cleaning of Stainless Steel some models Cleaning the Manual Clean Oven Regular oven models onlyGeneral Cleaning To Clean the Oven BottomSpecial Door Care Instructions Removing and Replacing the Oven DoorChanging the Oven Light Before you call Adjusting Your Oven TemperatureTo remove the hidden bake cover some models Occurrence Possible Cause / Solution Exclusions Major Appliance Warranty Information