Grounding Instructions

INSTALLATION OF MOUNTING ASSEMBLY

YOUR DISPOSER COMES WITH THE FOLLOWING MOUNT SYSTEM

1
	2
3
	4
5	C

Mount System

READ COMPLETELY BEFORE STARTING

NOTE: Pay close attention to the order of mount assembly parts, as they have been correctly assembled by the factory.

A.Evenly apply 1/2” thick rope of plumber’s putty around flange (1).

B.Press Flange (1) firmly into sink drain. Remove excess putty.

C.Insert fiber gasket (2), backup flange (3) and mounting ring (5). Hold in place while inserting snap ring (6).

D.Place a weight such as a disposer on the sink flange to hold it in place. Use a towel to prevent scratching sink. Pull snap ring open adn press firmly unitl it snaps into place.

E.Tighten the 1 2/3” screws (3) evenly and firmly against backup flange. Use shorter screws if sink is more than 3/8” thick.

FOR WASTE DISPOSERS EQUIPPED WITH A GROUNDED PLUG-IN POWER CORD.

This appliance must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.

FOR WASTE DISPOSERS NOT EQUIPPED WITH A GROUNDED PLUG-IN POWER CORD.

This appliance must be grounded. In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. The power cord (to be installed) must have an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordiances. Disconnect electric power to disposer circuit before installation. Turn the circuit breaker to the OFF position or remove the fuse.