Sonance 91652 instruction manual Introduction, Box Contents, Speaker Placement

Page 1

I N S T R U C T I O N M A N U A L

S O N A N C E C I N E M A ® S E R I E S I N - W A L L S P E A K E R S

Introduction

Thank you for purchasing Sonance Cinema® Series in-wall speak- ers. When properly installed, these speakers will deliver film soundtracks and music with outstanding clarity and realism, even in the largest home theater rooms. This manual covers the Sonance Cinema Series LCR1, LCR2, SUR1 and SUR2 models.

Box Contents

Each Sonance Cinema Series speaker box contains the following:

(1)Cinema Series LCR or SUR speaker

(1)Paintable grille

(1)Allen wrench

(1)Mounting cutout template

Speaker Placement

NOTE: CINEMA SPEAKERS CAN BE ORIENTED EITHER VERTICALLY OR HORIZONTALLY WITH NEARLY IDENTICAL PERFORMANCE. WHEN ORI- ENTING THE CINEMA SUR1 AND SUR2 HORIZONTALLY, ROTATE THE MIDRANGE/TWEETER PANEL 90° (SEE STEP 5, ON PAGE 2).

Left, Center & Right Channels

Left & Right Surround Speakers

Place the left & right surround speakers directly to the sides of the listening position, between 5 and 7 feet off the floor.

Use Figure 2 as a guide.

Surround Back Channel Speakers

The surround back speakers in

a6.1- or 7.1-channel system should be placed on the rear wall between 4 feet and 8 feet apart, at least 5 feet from the floor. Use Figure 3 as a guide.

5' – 7'

FIGURE 2: LEFT & RIGHT

SURROUND SPEAKER PLACEMENT

Place the left & right speakers on either side of the video screen, anywhere from 6 feet to 10 feet apart and 38 – 42 inches from the floor. The speakers should be at least 18 inches away from the side walls.

If possible, locate the center speaker at the same height as the left & right channel speakers (38 – 42 inches from the floor).

If you must place the center speaker above or below a video screen, place it no more than 2 feet above or below the center of the left and right speakers. This will maintain consistent tonality between all 3 front channel speakers.

The main listening position should be between 8 and 12 feet away from the speakers.

Use Figure 1 as a guide.

18"

6' – 10'

18"

Apart

From Side

 

From Side

Wall

 

Wall

2'

(max.)

FIGURE 1: LEFT, CENTER & RIGHT SPEAKER PLACEMENT

4' – 8'

5' – 7'

 

FIGURE 3: SURROUND BACK SPEAKER PLACEMENT

Before Installation

1.Determine the location for the speaker (see Speaker Placement).

2.Perform an obstruction survey to be certain that there are no studs, conduit, pipes, heating ducts, pocket doors or air returns in the wall cavity that will interfere with the speaker.

3. The

cutout

for

Cinema LCR1

and

SUR1

speakers

is

7 ½" x 20½" (191mm x 521mm). The cutout for Cinema

LCR2

and

SUR2

speakers is

7 ½" x

33 ½"

(191mm

x

851mm). There must be at least 3 7/8” (98mm) depth within the wall cavity for the speaker.

4.Position the included cutout template where the speaker is to be located and pencil an outline on the wall.

If you are unsure about obstructions, drill 2 – 4 small holes along the outline’s centerline and insert a coat hanger wire into each hole to feel-around for possible obstructions.

1

Image 1
Contents Speaker Placement Box ContentsBefore Installation IntroductionFront Speaker InstallationPainting the Speakers and Grilles SpecificationsLimited Lifetime Warranty Coverage U.S. Only Technical Assistance and ServiceExclusions And Limitations