Frigidaire FPGC3087MS Setting the Dual Ring Burner, Large Cookware Operation Zone a & B

SETTING THE DUAL RING BURNER

The Dual Ring Burner has two rings of flame that you can control for two different heat levels, one for small and one for large cookware.

Large Cookware Operation (Figure 1; Zone A & B)

1.Place a large cooking utensil centered over the dual surface Burner Grate.

2.Push the surface control knob down and turn counterclockwise out of the OFF position.

3.Release the knob and rotate to the LITE position (Figures 2 & 3). Note: All electronic surface ignitors will spark at the same time. However, only the selected surface burner will lit.

4.Visually check that the burner has lit.

5.When the burner is lit, continue to turn the control knob counterclockwise between the “HI” position and the “4” position (figure 3) to adjust to the desired flame size for both burners together. DO NOT cook with any of the surface control knobs in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position).

Figure 3

SETTING SURFACE CONTROLS

Simmering Operation (Figure 1; Zone A)

1.Place a small cooking utensil centered over the dual surface Burner Grate.

2.Push the surface control knob in and turn counterclockwise out of the OFF position (See Figures 2 & 3).

3.Release the knob and rotate to the LITE position. Note: All electronic surface ignitors will spark at the same time. However, only the Dual Burner will ignite.

4.Visually check that zone A & B of dual burner has lit.

5.Continue to turn the gas control knob counterclockwise past the “4” position; zone B will turn off. Adjust the simmer flame size by turning the control knob between the “4” position to the “LO” position (figure 3). DO NOT cook with the surface control knob in the LITE position (The electronic ignitor will continue to spark if the knob is left in the LITE position).

A B

Figure 1

Figure 2

Figure 4 9