Care and Cleaning, Care of Drain Air Gap

Care and Cleaning

Burn Hazard

Allow heating element to cool before cleaning the interior•

Failure to do so can result in burns.

f"%_LA.=JA
IJUL_lU_---Occasionally	wipe with a mild

nonabrasive detergent and water. Rinse and dry.

Inside--Theinside of the dishwasher,

including the filter, is self-cleaning with normal use• If needed, clean around the tub gasket area with a damp cloth.

Heating el

.........

Filte_ir.......

Spray arm/tower assembly

Note: Hard water may cause lime deposit buildup on the interior of the dishwasher. For cleaning

instructions see "Removing Spots and Film" section.

Overfill Protector--keeps dishwasher

from overfilling and is located in the left front corner of the tub.

•Clean occasionally with household

cleaner containing

vinegar or

bleach to dissolve

	any buildup.
•	Overfill	Protector		_
	should	move	up and
	down	freely	about
	one inch. If it does
	not move, lift and clean underneath.

Care of Drain Air Gap

If a drain air gap was installed for your built-in dishwasher, check to make sure it is clean so the dishwasher will drain properly. A drain air gap is usually mounted on countertop and can be inspected by removing the cover. This is not part of your dishwasher and is not covered by warranty.

Property Damage Hazard

Freezing temperatures may cause water lines to rupture• Be sure all supply lines to and circulating lines within dishwasher are protected•

Failure to do so could result in property damage.

Winterizing

be protected from freezing. Have a qualified person do the following:

A dishwasher left in an unheated place should

To Disconnect Service:

•Turn off electrical power to the dishwasher at the supply source by removing fuses or tripping circuit breaker.

2.Shut off water supply.

3.Place a pan under the inlet valve. Disconnect water line from inlet valve and drain into pan.

4.Disconnect drain line from pump and drain water into pan.

Note: See Installations Instructions for more

details.

To Restore Service:

1.Reconnect the water, drain, and electrical power supply•

2.Turn on water and electrical power supply•

3.Fill detergent cup(s) and run dishwasher through a NORMAL cycle•

4.Check connections to make sure they do not leak.

Note: See Installations Instructions for more

details•