Electrolux 95604 G, 95602 G, 95601 G, 95600 G Wiring diagram, Permanent Connection

Page 21

Permanent Connection

In the case of a permanent connection, it is necessary that you install a double pole switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type suitable for the required load in compliance with the current electric regulations.

The switch must not break the yellow and green earth cable at any point.

Ensure that the hob supply cord does not come into contact with surfaces with temperatures higher than 50 deg. C.

Wiring diagram

N

1

L

220 1

240

2

3

0

4

2

1.TAPS IGNITOR SWITCHES

2.IGNITOR UNIT

21

Image 21

Contents 95601 G 95602 G 95604 G Installation Child SafetyDuring Use Environmental Information ServiceContents Guide to Use the instructions Description of the Hob Model 95602 G InstallationHOB Burners OperationHob Top Maintenance and CleaningPan Supports BurnersSomething Not Working? Symptom Solution0870 5 929 Service and Spare PartsEuropean Guarantee Guarantee ConditionsEngineers technical data Instructions for the InstallerBurner Location Important safety requirementsInstallation This book be ignored Gas ConnectionCut Out Size BuildingBuilding over a cupboard or drawer Building over a kitchen unit with door Fitting the hob to the worktop This HOB Must be Earthed Electrical connectionsPermanent Connection Wiring diagramPreliminary Electrical Systems Check Fault FindingEarth Continuity Check Check gas supply at burner Ignition System / Gas IgnitionCommissioning Pressure TestingMethod Conversion from Natural Gas to LPG